Burkert Type 8619 User Manual
Page 22

20
Installationandwiring
Body
Screw
x4
Stage 2:
Prepare the 4 locking systems:
→
Insert a screw into each device.
→
Tighten the screw until the end of the shaft of the
screw is flush with the device.
Stage 3:
→
Slide the housing into the cut-out with the con-
nectors to the back until it can go no further.
1
2
Stage 4:
→
Insert (1) the hooks on the first locking system
into the slots on the housing.
→
Pull the locking system (2) until you hear a click.
The click may be heared when tightening the
locking system at stage 6.
Stage 5:
→
Place the locking system flush against the mul-
tiCELL by hand, so that the hooks remain in place.
Type 8619
english
See also other documents in the category Burkert Sensors:
- Type 1062 (112 pages)
- Type 1050 (4 pages)
- Type 8750 (64 pages)
- Type 8750 (82 pages)
- Type 8681 (40 pages)
- Type 8681 (90 pages)
- Type 8798 (2 pages)
- Type 8791 (4 pages)
- Type 8798 (106 pages)
- Type 8791 (15 pages)
- Type 8792 (136 pages)
- Type 8792 (252 pages)
- Type 8718 (34 pages)
- Type 8792 (118 pages)
- Type 8791 (106 pages)
- Type 8791 (184 pages)
- Type 8791 (28 pages)
- Type 8791 (21 pages)
- Type 8791 (154 pages)
- Type 0911 (64 pages)
- Type 0911 (84 pages)
- Type 0911 (76 pages)
- Type 0911 (46 pages)
- Type 1058 (31 pages)
- Type 1060 (4 pages)
- Type 1066 (112 pages)
- Type 1067 (158 pages)
- Type 1077-2 (33 pages)
- Type 1094 (82 pages)
- Type 1094 (126 pages)
- Type 1094 (12 pages)
- Type 1094 (41 pages)
- Type 1115 (25 pages)
- Type 1150 (99 pages)
- Type 1541 (2 pages)
- Type 5142 (6 pages)
- Type 8619 (40 pages)
- Type 8620 (177 pages)
- Type 8622 (4 pages)
- Type 8623 (90 pages)
- Type 8623 (130 pages)
- Type 8625 (118 pages)
- Type 8624 (124 pages)
- Type 8718 (4 pages)