Burkert Type 8619 - Manual (Page 33)

31
Adjustmentandcommissioning
8. ADjusTmenT AnD commissioninG
8.1. safety instructions
WarnIng
risk of injury due to non-conforming adjustment.
Non conforming adjustment could lead to injuries and damage the device and its environment.
• The operators in charge of adjustment must have read and understood the contents of this manual.
• In particular, observe the safety recommendations and intended use.
• The device/installation must only be adjusted by suitably trained staff.
WarnIng
Danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage the device and its surroundings.
• Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
manual.
• In particular, observe the safety recommendations and intended use.
• The device/installation must only be commissioned by suitably trained staff.
Before commissioning, calibrate each measuring sensor connected to the device.
8.2. switching on the device for the first time
When switching on the device for the first time, the display shows the first view in Process level:
13:40
mA
AO1
6.000
20.00
OFF DO2
mA
AO2
OFF DO1
OFF DI2
OFF DI1
MENU
M0:MAIN 2010/06/29
Figure 23 : Display when switching on for the first time
When switched on subsequently, the last active view in the Process leve is displayed. See chap. 8.8 to
browse in all views in Process level.
Type 8619
english