ABUS AZ4299 Terxon SX Base Kit with sounder Installation - Manual (Page 133)

57
UK
3. On the control unit, enter:
4. The control unit shows: SYSTEM TEST
5. If no fault exists and zones with the properties 24
hour, fire, panic or technical open are closed, you
exit the program menu.
6. If there is a fault, the alarm centre displays it.
Clear the fault and repeat steps 1–4.
126 Change language
To change the language used for the control unit display:
1. On the control unit, enter: 126
2. The LCD display shows: 126:Lang=English
3. Via the keypad, select from the following items
and press:
00 ENGLISH
01 ITALIAN
02 ESPANOL
03 PORT
04 NEDERL
05 FRANCAI
06 GERMAN
07 NORW.
08 SWED.
09 DANSK
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
151 Additional outputs
By using the cable supplied or the optional relay PCB, you
have access to eight further transistor outputs. To change
the setting of output 1:
1. On the control unit, enter: 151
2. The LCD display shows: 151:Fire
3. Via the keypad, select from the following items
and press:
00 Not Used
01 Fire
02 PA
03 Burglar
04 Open / Closed
05 Alarm Abort
06 Technical Alarm
07 Alarm Confirmation
08 RF Low Battery
09 RF Supervision Loss
10 RF Jamming
11 AC Fail
12 Tamper Alarm
13 Open
14 Close
15 Zone Omitted
16 Medical
17 Keybox
18 Anti-Mask
19 Smoke Detector
30 Set 1
31 Set 2
32 Set 3
33 Set 4
34 Unset 1
35 Unset 2
36 Unset 3
37 Unset 4
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.