Asus GigaX2024SX - Manual (Page 91)

-Flow control can eliminate frame loss by “blocking” traffic from end stations or
he switch when its buffers fill. When enabled,
operation and IEEE 802.3x for full-duplex
operation. (Avoid using flow control on a port connected to a hub unless it is
-TX –
10half, 10full, 100half, 100full; 1000BASE-T – 10half, 10full, 100half, 100full,
1000full)
ember of a trunk. To create trunks and select
port members, see “Creating Trunk Groups” on page 3-93.
or Trunk Configuration. Modify the required
segments connected directly to t
back pressure is used for half-duplex
actually required to solve a problem. Otherwise back pressure jamming signals
may degrade overall performance for the segment attached to the hub.)
(Default: Autonegotiation enabled; Advertised capabilities for 100BASE
1000full; 1000BASE-SX/LX/LH –
• Trunk – Indicates if a port is a m
Note: Auto-negotiation must be disabled before you can configure or force the
interface to use the Speed/Duplex Mode or Flow Control options.
onfiguration Web – Click Port, Port C
interface settings, and click Apply.
Figure 3-41. Port/Trunk Configuration
CLI – Select the interface, and then enter the required settings.
3-66