Asus GigaX2024SX - Manual (Page 359)

4-191
IP Interface Commands
There are no IP addresses assigned to this switch by default. You must manually
configure a new address to manage the switch over your network or to connect
the switch to existing IP subnets. You may also need to a establish a default
gateway between this device and management stations or other devices that exist
on another network segment.
Basic IP Configuration
ip address
This command sets the IP address for the currently selected VLAN interface. Use
the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Default Setting
DHCP
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management access over