Asus GigaX2024SX - Manual (Page 79)

address, the switch will reject the connection, enter an event message in
thesystem log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access respectively.
Each of these groups can include up to five different sets of addresses, either
When entering addresses for the same group (i.e., SNMP, web or Telnet), the
ures IP address(es) for the Telnet group.
IP Filter List –IP address which are allowed management access to this
interface.
• Start IP Address –
ss of a range.
End IP Address –
–
The end address of a range.
Web – Click Security, IP Filter. Enter the start and end IP addresses, and click
Add Web IP Filtering Entry to update the filter list.
individual addresses or address ranges.
•
switch will not accept overlapping address ranges. When entering addresses for
different groups, the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must delete
the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by
specifying both the start address and end address.
Command Attributes
• Web IP Filter –Configures IP address(es) for the web group.
• SNMP IP Filter –Configures IP address(es) for the SNMP group
• Telnet IP FIlter – Config
•
A single IP address, or the starting addre
•
• Add/Remove Web IP Filtering Entry – Adds/removes an IP address from the
list.
3-54