Asus GigaX2024SX - Manual (Page 289)

Rate Limit Commands
This function allows the network manager to control the maximum rate for traffic
transm
iting is configured on interfaces at
twork to limit traffic into or out of the network. Traffic that falls
with ceed the acceptable
e dropped.
g can be applied to individual ports or trunks. When an interface is
configured with this feature, the traffic rate will be monitored by the hardware to
verify conformity. Non-conforming traffic is dropped, conforming traffic is
forwarded without any changes.
y” is an additional feature enabling the network
r control over traffic on the network. The “rate limit granularity” is
multiplied by the “rate limit” (page 4-162) to set the actual rate limit for an
interface. Granularity is aglobal setting that applies to Fast Ethernet or Gigabit
itted or received on an interface. Rate lim
the edge of a ne
inthe rate limit is transmitted, while packets that ex
amount of traffic ar
Rate limitin
Note:The “Rate limit granularit
manager greate
Ethernet interfaces.
ra
Use this command to define the rate limit level for a specific interface. Use this
command without specifying a rate to restore the default rate limit level. Use the
the default status of disabled.
Syn
output} level [rate]
Interface Configuration (Ethernet, Port Channel)
te-limit
no form to restore
tax
rate-limit {input |
no rate-limit {input | output}
• input – Input rate
• output – Output rate
• rate – Maximum value. (Range: 1-30)
Default Setting
30
Command Mode
4-121