Asus GigaX2024SX - Manual (Page 273)

snmp-server host
This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the no form to remove the specified host.
S
- Password-like community string sent with the notification
operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you define this
string using the snmp-server community command prior to using the
snmp-server host command. (Maximum length: 32 characters)
• version - Specifies whether to send notifications as SNMP v1 or v2c traps.
Default Setting
Host Address: None
SNMP Version: 1
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server host command, no notifications are sent.
In order to configure the switch to send SNMP notifications, you must enter at
least one snmp-server host command. In order to enable multiple hosts, you
must issue a separate snmp-server host command for each host.
t command is used in conjunction with the
command. Use the snmp-server enable traps
command to specify which SNMP notifications are sent globally. For a host to
snmp-server enable traps command and the
host command for that host must be enabled.
or example, some notification types are always enabled.
n send SNMP version 1 or version 2c notifications to a host IP
address, depending on the SNMP version that the management station
nmp-server host command does not specify the SNMP version,
the default is to send SNMP version 1 notifications.
yntax
snmp-server host host-addr community-string [version {1 | 2c}]
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• community-string
• The snmp-server hos
snmp-server enable traps
receive notifications, at least one
snmp-server
• Some notification types cannot be controlled with the snmp-server enable
traps command. F
• The switch ca
supports. If the s
Example
Related Commands
snmp-server enable traps (4-142)
snmp-server enable traps
This command enables this device to send Simple Network Management Protocol
traps (SNMP notifications). Use the no form to disable SNMP notifications.
yntax
p-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure traps.
S
[no] snm
4-105