Asus GigaX2024SX - Manual (Page 198)

IP Filter Commands
m
T
allowed management
the switch through various protocols. Use the no form to restore the
[no] management {all-client | http-client | snmp-client | telnet-client}
start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, Web and Telnet groups.
address(es) to the Web group.
• snmp-client - Adds IP address(es) to the SNMP group.
•
dress(es) to the Telnet group.
rt-address - A single IP address, or the starting address of a range.
Setting
G
C
•
e on the switch from an invalid
ad the
system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, Web and Telnet access respectively.
oups can include up to five different sets of addresses, either
ual addresses or address ranges.
dresses for the same group (i.e., SNMP, Web or Telnet), the
cept overlapping address ranges. When entering addresses for
switch will accept overlapping address ranges.
the entire range, and reenter the addresses.
the start address, or by
nd end address.
Example
ple restricts management access to the indicated addresses.
anagement
his command specifies the client IP addresses that are
access to
default setting.
Syntax
• http-client - Adds IP
telnet-client - Adds IP ad
• sta
• end-address - The end address of a range.
Default
All addresses
Command Mode
lobal Configuration
ommand Usage
If anyone tries to access a management interfac
dress, the switch will reject the connection, enter an event message in
Each of these gr
individ
• When entering ad
switch will not ac
different groups, the
• You cannot delete an individual address from a specified range. You must
delete
• You can delete an address range just by specifying
specifying both the start address a
This exam
4-30