Asus GigaX2024SX - Manual (Page 293)

D
The current port will be added to this trunk.
C
e
tandard.
• Use no channel-group to remove a port group from a trunk.
es port-channel to remove a trunk from the switch.
ple creates trunk 1 and then adds port 11:
efault Setting
ommand Mode
Interface Configuration (Ethernet)
Command Usag
• When configuring static trunks, the switches must comply with the Cisco
EtherChannel s
• Use no interfac
Example
The following exam
lacp
T
c
S
D
Command Mode
nfiguration (Ethernet)
either by forced mode or auto-negotiation.
• A trunk formed with another switch using LACP will automatically be assigned
the next available port-channel ID.
itch has also enabled LACP on the connected ports, the trunk
ditional ports will be placed in standby mode, and will only be enabled if
one of the active links fails.
T 11-13. Because LACP has also been
en show interfaces status
por has been established.
his command enables 802.3ad Link Aggregation Control Protocol (LACP) for the
urrent interface. Use the no form to disable it.
yntax
[no] lacp
efault Setting
Disabled
ce Co Interfa
Command Usage
• The ports on both ends of an LACP trunk must be configured for full duplex,
• If the target sw
will be activated automatically.
• If more than four ports attached to the same target switch have LACP enabled,
the ad
Example
he following shows LACP enabled on ports
abled on the ports at the other end of the links, the
t-channel 1 command shows that Trunk 1
4-125