Asus GigaX2024SX User Manual
Page 248
Port Security Commands
e learning function or manually
ure addresses for a port. You may want to leave port security off for an
initial training period (i.e., enable the learning function) to register all the current
VLAN members on the selected port, and then enable port security to ensure that
ming frames with a source MAC address that is
unknown or has been previously learned from another port.
These commands can be used to disable th
specify sec
the port will drop any inco
p
T
ke
form with the appropriate keyword
efault settings for a response to security violation or for the
maximum number of allowed addresses.
S
tion {shutdown | trap | trap-and-shutdown}
[action | max-mac-count]
y is violated.
wn - Disable port only.
Issue SNMP trap message and disable port.
• max-mac-count
- address-count - The maximum number of MAC addresses that can be
learned on a port. (Range: 0-20)
Default Setting
Maximum Addresses: 0
ch will stop dynamically learning new
incoming traffic with source addresses
the dynamic or static address table will be accepted.
urity, first allow the switch to dynamically learn the ort security ywords to disable port security. Use the no to restore the d yntax port security [ac Status: Disabled Command Mode figuration (Ethernet) Interface Con Command Usage • If you enable port security, the swit e specified port. Only addresses on th in already stored then enable port security to stop address learning. Be sure you period, and 4-80
his command enables or configures port security. Use the no form without any
| max-mac-count address-count]
no port security
• action - Response to take when port securit
- shutdo
- trap - Issue SNMP trap message only.
- trap-and-shutdown -
Action: None
• To use port sec
MAC address, VLAN> pair for frames received on a port for an initial training