Asus GigaX2024SX - Manual (Page 127)

• Default: 128
• Range: 0-240, in steps of 16
• Path Cost – This parameter is used by the STP to determine the best path
between devices. Therefore, lower values should be assigned to ports attached to
faster media, and higher values assigned to ports with slower media. (Path cost
takes precedence over port priority.) Note that when the Path Cost Method is set
to short (page 3-63), the maximum path cost is 65,535.
• Range –
- Ethernet: 200,000-20,000,000
- Fast Ethernet: 20,000-2,000,000
- Gigabit Ethernet: 2,000-200,000
• Default –
- Ethernet – Half duplex: 2,000,000; full duplex: 1,000,000; trunk: 500,000
- Fast Ethernet – Half duplex: 200,000; full duplex: 100,000; trunk: 50,000
- Gigabit Ethernet – Full duplex: 10,000; trunk: 5,000
• Admin Link Type – The link type attached to this interface.
- Point-to-Point – A connection to exactly one other bridge.
- Shared – A connection to two or more bridges.
- Auto – The switch automatically determines if the interface is attached to a
point-to-point
)
• Admin Edge Port (Fast Forwarding) – You can enable this option if an interface
anning tree forwarding state. Specifying Edge Ports provides
quicker convergence for devices such as workstations or servers, retains the
tree to initiate reconfiguration when the interface changes state, and
also overcomes other STA-related timeout problems. However, remember that
d for ports connected to an end-node device.
(Default: Disabled)
• Migration – If at any time the switch detects STP BPDUs, including
P-compatible) to send on the selected interfaces. (Default: Disabled)
Tree, STA, Port Configuration or Trunk Configuration.
link or to shared media. (This is the default setting.
is attached to a LAN segment that is at the end of a bridged LAN or to an end
node. Since end nodes cannot cause forwarding loops, they can pass directly
through to the sp
current forwarding database to reduce the amount of frame flooding required to
rebuild address tables during reconfiguration events, does not cause the
spanning
Edge Port should only be enable
Configuration or Topology Change Notification BPDUs, it will automatically set the
selected interface to forced STP-compatible mode. However, you can also use
the Protocol Migration button to manually re-check the appropriate BPDU format
(RSTP or ST
Web – Click Spanning
Modify the required attributes, then click Apply.
3-102