Asus GigaX2024SX - Manual (Page 164)

Displaying Interfaces Attached to a Multicast Router
at are attached to ports on the switch use information obtained
a multicast routing protocol such as DVMRP or PIM, to
ing across the Internet. These routers may be dynamically
e the Multicast Router Port Information page to display the ports on
is switch
ciated multicast
Multicast routers th
from IGMP, along with
support IP multicast
discovered by the switch or statically assigned to an interface on the switch.
You can us
this switch attached to a neighboring multicast router/switch for each VLAN ID.
Command Attributes
• VLAN ID – ID of configured VLAN (1-4094).
• Multicast Router List – Multicast routers dynamically discovered by th
or those that are statically assigned to an interface on this switch.
Web – Click IGMP Snooping, Multicast Router Port Information. Select the
required VLAN ID from the scroll-down list to display the asso
routers.
Figure 3-83. Displaying Multicast Router Port Information
CLI – This example shows that Port 11 has been statically configured as a port
router. attached to a multicast
Specifying Static Interfaces for a Multicast Router
Depending on your network connections, IGMP snooping may not always be able
fore, if the IGMP querier is a known multicast
over the network to an interface (port or trunk) on your
a specified VLAN) to join all
st groups supported by the attached router. This can ensure
fic is passed to all the appropriate interfaces within the switch.
tes
the Port or Trunk scroll down list.
to locate the IGMP querier. There
router/ switch connected
switch, you can manually configure the interface (and
the current multica
that multicast traf
Command Attribu
• Interface – Activates
3-139