Asus GigaX2024SX - Manual (Page 303)

Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
mac-address-table static
his command maps a static address to a destination port in a VLAN. Use the no
ddress.
ntax
mac-address-table static mac-address interface interface
an-id [action]
no mac-address-table static mac-address vlan vlan-id
- MAC address.
•
ort
- u
ort number.
• vlan-id - VLAN ID (Range: 1-4094)
• action -
- delete-on-reset - Assignment lasts until the switch is reset.
T
form to remove an a
Sy
vlan vl
• mac-address
interface
• ethernet unit/p
nit - This is device 1.
- port - P
• port-channel channel-id (Range: 1-4)
- permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
4-135