Asus GigaX2024SX - Manual (Page 243)

verified first. If the RADIUS serve
attempted on the TACACS+ server. If the r is not available, then authentication is
TACACS+ server is not available, the
local user name and password is checked.
Example
R
enable password-sets the password for changing command modes (4-37)
R
Remote Authentication Dial-in User Service (RADIUS) is a logon authentication
protocol that uses software running on a central server to control access to
R
authentication server contains a
iple user name/password pairs with associated privilege levels
that require management access to a switch.
elated Commands
ADIUS Client
ADIUS-aware devices on the network. An
database of mult
for each user or group
radius-server host
This command specifies primary and backup RADIUS servers and authentication
parameters that apply to each server. Use the no form to restore the default
values.
Syntax
[no] radius-server index host {host_ip_address | host_alias}
[auth-port auth_port] [timeout timeout] [retransmit retransmit] [key key]
• index - Allows you to specify up to five servers. These servers are queried
in sequence until a server responds or the retransmit period expires.
• host_ip_address - IP address of server.
• host_alias - Symbolic name of server. (Maximum length: 20 characters)
• port_number - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
• timeout - Number of seconds the switch waits for a reply before resending a
request. (Range: 1-65535)
• retransmit - Number of times the switch will try to authenticate logon access
via the RADIUS server. (Range: 1-30)
• key - Encryption key used to authenticate logon access for client. Do not use
4-75