Asus GigaX2024SX - Manual (Page 225)

16 seconds
Command Mode
Global Configuration
Command Usage
This command is only applicable when the switch is set to SNTP client mode.
Example
Related Commands
sntp client (4-73)
show sntp
This command displays the current time and configuration settings for the SNTP
client, and indicates whether or not the local time has been properly updated.
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command displays the current time, the poll interval used for sending
time synchronization requests ,and the current SNTP mode (i,e.,unicast )
Example
clock timezone
This command sets the time zone for the switch’s internal clock.
S
e hour hours minute minutes {before-utc | after-utc}
- Name of timezone, usually an acronym. (Range: 1-29 characters)
f hours before/after UTC. (Range: 1-12 hours)
minutes before/after UTC. (Range: 0-59 minutes)
the local time zone before (east) of UTC.
•
D
C
C
and sets the local time zone relative to the Coordinated Universal Time
(UTC, formerly Greenwich Mean Time or GMT), based on the earth’s prime
s longitude. To display a time corresponding to your local
time, you must indicate the number of hours and minutes your time zone is east
(before) or west (after) of UTC.
yntax
clock timezone nam
• name
• hours - Number o
• minutes - Number of
• before-utc - Sets
after-utc - Sets the local time zone after (west) of UTC.
efault Setting
None
ommand Mode
Global Configuration
ommand Usage
This comm
meridian, zero degree
4-57