Ocean Optics S2000 - Manual (Page 99)

Interrupt Request Settings for the ADC500
To change the IRQ settings on the ADC500 board, see the bank of 4 dip switches labeled SW2. In the default
setting, the IRQ is set to 7. Other combinations for IRQ settings are below. After you have changed the switches,
reinstall the card and change the software settings to match the hardware settings. (See pages 15-18 for
instructions.) The gray block indicates the position of the switch.
Appendix A
- 99 -
Switch # 1 2 3 4
ON
OFF
IRQ value 3 5 7
Value as shown 3
Switch # 1 2 3 4
ON
OFF
IRQ value 3 5 7
Value as shown 5
Switch # 1 2 3 4
ON
OFF
IRQ value 3 5 7
Value as shown 7
Interrupt Request 7 (Default Setting)
Interrupt Request 5
Interrupt Request 3
sw itch is in the on, upw ard position =