Ocean Optics S2000 - Manual (Page 10)

Configure Data Acquisition Dialog Box
Finally, select Spectrum | Configure Data Acquisition from the menu to open the Configure Data Acquisition
dialog box and to set your data acquisition parameters such as the integration time, averaging and boxcar
smoothing, and several other parameters.
For detailed information on connecting and operating sampling optics such as light sources, sampling chambers,
fibers, or any other Ocean Optics spectroscopic accessory, check the
Table of Contents to find operating
instructions on a specific component.
The following are typical configurations for absorbance, transmission, irradiance, and reflection experiments.
Absorbance/Transmission Setup
Irradiance Setup
Reflection Setup
Run OOIBase32 in Scope Mode and take a dark spectrum and a reference spectrum (see the Experiment Tutorial
section for details). Choose the absorbance, transmission, or relative irradiance mode to take your sample
measurements. For detailed information on OOIBase32 functions and features, refer to the
OOIBase32
Spectrometer Operating Software Manual.
Quick Start
- 10 -
Step 4: Connect Sampling Optics
Step 5: Start the Software and Receive Data