Ocean Optics S2000 - Manual (Page 108)

Appendix E: PC2000 Pin-outs and Jumpers
The average user would not normally need to know about the interconnect scheme of the S2000, as the
cables supplied with all of the units need only be plugged into the matching connectors on the hardware.
However, if the need arises to design and fabricate your own cabling system, the following tables supply the
necessary information.
- 108 -
H1 Header Block
Pin Function
1 Channel 1 (slave 1)
2 Channel 2
3 Channel 3
4 Channel 4
5 Channel 5
6 Channel 6
7 Channel 7
8 GND
9 GND
10 S0
11 Reserved
12 Multiple Strobe
13 Single Strobe
14 Reserved
15 F read (ROG)
16 F clock
J2 (D-SUB-15) Accessory Connector
Pin Function
1 Strobe Single Fire
2 Strobe Multiple Fire
3 +5 VDC
4 External Hardware Trigger
5 External Synchronization Trigger
6 Analog Channel 7 Input
7 Analog Channel 6 Input
8 External Software Trigger
9 Analog Channel 1
10 Ground
11 Analog Channel 4
12 Analog Channel 5
13 Digital Out 0 (Strobe Enable or Lamp On/Off)
14 Analog Channel 3
15 Analog Channel 2