QTECH QSW-3400 Инструкция по настройке - Manual (Page 463)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
462
7. Set the max output power on specified ports
8. Set the power priority on specified ports
68.3 Typical Application of PoE
Requirements of Network Deployment
Set the max output power of the switch to 150W, assuming that the default max power can
satisfy the requirements.
Ethernet interface 1/2 is connected to an IP phone.
Ethernet interface 1/4 is connected to a wireless AP.
Ethernet interface 1/6 is connected to a Bluetooth AP.
Ethernet interface 1/8 is connected to a network camera.
The IP phone connected to Ethernet interface has the highest-level power supply priority:
critical, which requires the power supply to the newly connected PD being cut off if it causes
PSE power-overload (i.e. adopting the priority policy of PD power management).
Power of subordinate AP devices connected to Ethernet interface 1/6 should not exceeds
9000mW.
Topology of Network
no power inline enable
Command Explanation
Port Mode
power inline max
no power inline max
Set the max output power on specified
ports.
Command Explanation
Port Mode
power inline priority {critical | high | low} Set the power priority on specified ports.