QTECH QSW-3400 Инструкция по настройке - Manual (Page 334)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
333
dot1x guest-vlan
no dot1x guest-vlan
Set the guest vlan of the specified port; the no
command is used to delete the guest vlan.
dot1x portbased mode single-mode
no dot1x portbased mode single-mode
Set the single-mode based on portbase
authentication mode; the no command
disables this function.
(3) Configure expanded 802.1x function
Command Explanation
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
Enables the 802.1x address filter function in the switch; the
no command disables the 802.1x address filter function.
dot1x macbased port-down-
flush
no dot1x macbased port-
down-flush
Enables this command, when the dot1x certification
according to mac is down, delete the user who passed the
certification of the port; The no command does not make the
down operation.
dot1x accept-mac
address> [interface
]
no dot1x accept-mac
address> [interface
]
Adds 802.1x address filter table entry, the no command
deletes 802.1x filter address table entries.
dot1x eapor enable
no dot1x eapor enable
Enables the EAP relay authentication function in the switch;
the no command sets EAP local end authentication.
(4) Configure IPv6 passthrough function of the port
Command Explanation
Port Mode
dot1x ipv6 passthrough
no dot1x ipv6 passthrough
Enables IPv6 passthrough function of global mode on a
switch, only applicable when access control mode is
userbased; the no operation of this command will disable
the function.
3. Supplicant related property configuration
Command Explanation
Global Mode
dot1x max-req
no dot1x max-req
Sets the number of EAP request/MD5 frame to be sent
before the switch re-initials authentication on no supplicant