QTECH QSW-3400 Инструкция по настройке - Manual (Page 45)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
44
6. Configure group
Command Explanation
Global Mode
snmp-server group
{noauthnopriv|authnopriv|authpriv} [[read
] [write ] [notify
]] [access {
std>|}] [ipv6-access {
std>|}]
no snmp-server group
{noauthnopriv|authnopriv|authpriv}
[access {|}] [ipv6-access
{|}]
Set the group information on the switch. This
command is used to configure VACM for
SNMP v3.
7. Configure view
Command Explanation
Global Mode
snmp-server view
string> {include|exclude}
no snmp-server view [
string>]
Configure view on the switch. This command
is used for SNMP v3.
8. Configuring TRAP
Command Explanation
Global Mode
snmp-server enable traps
no snmp-server enable traps
Enable the switch to send Trap message. This
command is used for SNMP v1/v2/v3.
snmp-server host { |
} {v1 | v2c | {v3
{noauthnopriv | authnopriv | authpriv}}}
no snmp-server host {
address> | } {v1 | v2c |
{v3 {noauthnopriv | authnopriv | authpriv}}}
Set the host IPv4/IPv6 address which is used
to receive SNMP Trap information. For SNMP
v1/v2, this command also configures Trap
community string; for SNMP v3, this
command also configures Trap user name
and security level. The
“no” form of this
command cancels this IPv4 or IPv6 address.
snmp-server trap-source { | Set the source IPv4 or IPv6 address which is