QTECH QSW-3400 Инструкция по настройке - Manual (Page 419)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
418
2. Specify mirror source port(CPU)
Command Explanation
Global mode
monitor session source
{interface | cpu} {rx| tx|
both}
no monitor session source
{interface | cpu}
Specifies mirror source port; the no command
deletes mirror source port.
3. Specify flow mirror source
Command Explanation
Global mode
monitor session source {interface
} access-group {rx|tx|both}
no monitor session source {interface
} access-group
Specifies flow mirror source port
and apply rule; the no command
deletes flow mirror source port.
56.3 Mirror Examples
Example:
The requirement of the configurations is shown as below: to monitor at interface 1 the data
frames sent out by interface 9 and received from interface 7, sent and received by CPU, and
the data frames received by interface 15 and matched by rule 120(The source IP address is
1.2.3.4 and the destination IP address is 5.6.7.8).
Configuration guidelines:
1. Configure interface 1 to be a mirror destination interface.
2. Configure the interface 7 ingress and interface 9 egress to be mirrored source.
3. Configure the CPU as one of the source.
4. Configure access list 120.
5. Configure access 120 to binding interface 15 ingress.
Configuration procedure is as follows:
Switch(config)#monitor session 1 destination interface ethernet 1/1
Switch(config)#monitor session 1 source interface ethernet 1/7 rx
Switch(config)#monitor session 1 source interface ethernet 1/9 tx