QTECH QSW-3400 Инструкция по настройке - Manual (Page 357)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
356
3. Configure the RADIUS server
Command Explanation
Global Mode
radius-server authentication host {
address> | } [port
number>] [key {0 | 7} ] [primary]
[access-mode {dot1x | telnet}]
no radius-server authentication host
{ |
Specifies the IPv4/IPv6 address and the port
number, whether be primary server for
RADIUS accounting server; the no command
deletes the RADIUS accounting server.
radius-server accounting host {
address> | } [port
number>] [key {0 | 7} ] [primary]
no radius-server accounting host {
address> | }
Specifies the IPv4/IPv6 address and the port
number, whether be primary server for
RADIUS accounting server; the no command
deletes the RADIUS accounting server.
4. Configure the parameter of the RADIUS service
Command Explanation
Global Mode
radius-server dead-time
no radius-server dead-time
To configure the interval that the RADIUS
becomes available after it is down. The no
form of this command will restore the default
configuration.
radius-server retransmit
no radius-server retransmit
To configure retry times for the RADIUS
packets. The no form of this command
restores the default configuration.
radius-server timeout
no radius-server timeout
To configure the timeout value for the
RADIUS server. The no form of this command
will restore the default configuration.
radius-server accounting-interim-update
timeout
no radius-server accounting-interim-
update timeout
To configure the update interval for
accounting. The no form of this command will
restore the default configuration.
5. Configure the IP address of the RADIUS NAS
Command Explanation
Global Mode
radius nas-ipv4 To configure the source IP address for the