QTECH QSW-3400 Инструкция по настройке - Manual (Page 24)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
23
Switch(config)#username test privilege 15 password 0 test
Switch(config)#authentication line vty login local
Enter valid login name and password in the Telnet configuration interface, Telnet user will be
able to enter the switch’s CLI configuration interface. The commands used in the Telnet CLI
interface after login is the same as that in the Console interface.
Telnet Configuration Interface
1.1.2.2 Management via HTTP
To manage the switch via HTTP, the following conditions should be met:
1. Switch has an IPv4/IPv6 address configured;
The host IPv4/IPv6 address (HTTP client) and the switch’s VLAN interface IPv4/IPv6 address
are in the same network segment;
If 2. is not met, HTTP client should connect to an IPv4/IPv6 address of the switch via other
devices, such as a router.
Similar to management the switch via Telnet, as soon as the host succeeds to ping/ping6 an
IPv4/IPv6 address of the switch and to type the right login password, it can access the switch
via HTTP. The configuration list is as below:
Step 1: Configure the IP addresses for the switch and start the HTTP server function on the
switch.
For configuring the IP address on the switch through out-of-band management, see the telnet