QTECH QSW-3400 Инструкция по настройке - Manual (Page 393)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
392
binding, but does not limit the static binding
number.
11. Configure the check mode for SAVI conflict binding
Command Explanation
Global mode
savi check binding mode
no savi check binding mode
Configure the check mode for the conflict
binding, no command deletes the check
mode.
12. Enable or disable user authentication
Command Explanation
Port mode
savi ipv6 check source [ip-address mac-
address | ip-address | mac-address]
no savi ipv6 check source
Enable the control authentication function for
user, no command disables the function.
13. Enable or disable DHCPv6 trust of port
Command Explanation
Port mode
ipv6 dhcp snooping trust
no ipv6 dhcp snooping trust
Enable DHCPv6 trust port, no command
disables the trust function. (port is translated
from trust port into untrust port)
14. Enable or disable ND trust of port
Command Explanation
Port mode
ipv6 nd snooping trust
no ipv6 nd snooping trust
Configure a port as slaac trust and RA trust,
no command deletes the port’s trust function.
15. Configure the binding number
Command Explanation
Port mode
savi ipv6 binding num
no savi ipv6 binding num
Configure the binding number of a port, no
command restores the default value. Note:
The binding number only limits the dynamic