QTECH QSW-3400 Инструкция по настройке - Manual (Page 292)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
291
ipv6 mld snooping vlan
query-robustness
no ipv6 mld snooping vlan
query-robustness
Configure the query robustness, the “no” form of this
command restores to the default.
ipv6 mld snooping vlan
suppression-query-time
no ipv6 mld snooping vlan
suppression-query-time
Configure the suppression query time. The “no” form
of this command restores to the default
Ipv6 mld snooping vlan
static-group [source
] interface [ethernet |
port-channel]
no ipv6 mld snooping vlan
static-group [source
] interface [ethernet |
port-channel]
Configure static-group on specified port of the VLAN.
The no form of the command cancels this
configuration.
37.1.3 MLD Snooping Examples
Scenario 1: MLD Snooping Function
Open the switch MLD Snooping Function figure
As shown above, the vlan 100 configured on the switch consists of ports 1, 2, 6, 10 and 12.
Four hosts are respectively connected to 2, 6, 10 and 12 while the multicast router on port 1.
Suppose we need MLD Snooping on VLAN 100, however by default, the global MLD Snooping
as well as the MLD Snooping on each VLAN are, therefore first we have to enable the global
MLD Snooping at the same time enable the MLD Snooping on VLAN 100, furthermore we
Multicast Router
Mrouter Port
MLD Snooping
Switch
Group
1
Group
1
Group
1
Group
2