QTECH QSW-3400 Инструкция по настройке - Manual (Page 137)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
136
Connect the Trunk ports of both switches for a Trunk link to convey the cross-switch VLAN
traffic; connect all network devices to the other ports of corresponding VLANs.
In this example, port 1 and port 12 are spared and can be used for management port or for
other purposes.
The configuration steps are listed below:
Switch A:
Switch(config)#vlan 2
Switch(Config-Vlan2)#switchport interface ethernet 1/2-4
Switch (Config-Vlan2)#exit
Switch (config)#vlan 100
Switch (Config-Vlan100)#switchport interface ethernet 1/5-7
Switch (Config-Vlan100)#exit
Switch (config)#vlan 200
Switch (Config-Vlan200)#switchport interface ethernet 1/8-10
Switch (Config-Vlan200)#exit
Switch (config)#interface ethernet 1/11
Switch (Config-If-Ethernet1/11)#switchport mode trunk
Switch(Config-If-Ethernet1/11)#exit
Switch(config)#
Switch B:
Switch(config)#vlan 2
Switch(Config-Vlan2)#switchport interface ethernet 1/2-4
Switch (Config-Vlan2)#exit
Switch (config)#vlan 100
Switch (Config-Vlan100)#switchport interface ethernet 1/5-7
Switch (Config-Vlan100)#exit
Switch (config)#vlan 200
Switch (Config-Vlan200)#switchport interface ethernet 1/8-10
Switch (Config-Vlan200)#exit
Switch (config)#interface ethernet 1/11
Switch (Config-If-Ethernet1/11)#switchport mode trunk
Switch (Config-If-Ethernet1/11)#exit
18.1.4 Typical Application of Hybrid Port
Scenario: