QTECH QSW-3400 Инструкция по настройке - Manual (Page 114)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
113
query the last abnormity status through executing the commands. When the user finds the
abnormity information of the fiber module, the fiber module information may be remonitored
after processing the abnormity information, here, the user is able to know the abnormity
information and renew the monitoring.
14.2 DDM Configuration Task List
DDM configuration task list:
1. Show the real-time monitoring information of the transceiver
2. Configure the alarm or warning thresholds of each parameter for the transceiver
3. Configure the state of the transceiver monitoring
(1) Configure the interval of the transceiver monitoring
(2) Configure the enable state of the transceiver monitoring
(3) Show the information of the transceiver monitoring
(4) Clear the information of the transceiver monitoring
1. Show the real-time monitoring information of the transceiver
2. Configure the alarm or warning thresholds of each parameter for the transceiver
3. Configure the state of the transceiver monitoring
(1) Configure the interval of the transceiver monitoring
Command Explanation
Global mode
transceiver-monitoring interval
no transceiver-monitoring interval
Set the interval of the transceiver
monitor. The no command sets the
interval to be the default interval of 15
minutes.
Command Explanation
Port mode
transceiver threshold {default | {temperature |
voltage | bias | rx-power | tx-power} {high-alarm |
low-alarm | high-warn | low-warn} { |
default}}
Set the threshold defined by the user.
Command Explanation
Global mode