QTECH QSW-3400 Инструкция по настройке - Manual (Page 364)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
363
Firstly, SSL should be enabled on the switch. When the client tries to access the
switch through https method, a SSL session will be set up between the switch and the
client. When the SSL session has been set up, all the data transmission in the application
layer will be encrypted.
Configuration on the switch:
Switch(config)# ip http secure-server
Switch(config)# ip http secure-port 1025
Switch(config)# ip http secure-ciphersuite rc4-128-sha
46.4 SSL Troubleshooting
In configuring and using SSL, the SSL function may fail due to reasons such as physical
connection failure or wrong configurations. The user should ensure the following:

First good condition of the physical connection;
 Second all interface and link protocols are in the UP state (use “show interface”
command);

Then, make sure SSL function is enabled (use ip http secure-server command );
 Don’t use the default port number if configured port number, pay attention to the port
number when input the web wide;

If SSL is enabled, SSL should be restarted after changes on the port configuration and
encryption configuration;

IE 7.0 or above should be used for use of des-cbc-sha;
Web Server
Malicious Users
PC Users
Date Acquisition Fails
SSLSession
Connected
Web Browser https