QTECH QSW-3400 Инструкция по настройке - Manual (Page 208)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
207
Command Explanation
Interface Configuration Mode
ipv6 address
length> [eui-64]
no ipv6 address
length>
Configure IPv6 address, including aggregatable
global unicast addresses, site-local addresses and
link-local addresses. The no ipv6 address
address/prefix-length> command cancels IPv6
address.
(2) Configure default gateway
Command Explanation
Global Mode
ipv6 default-gateway
no ipv6 default-gateway
Configure IPv6 default gateway of the router. The
no command cancels the configuration.
2. IPv6 Neighbor Discovery Configuration
(1) Configure DAD Neighbor solicitation Message number
Command Explanation
Interface Configuration Mode
ipv6 nd dad attempts
no ipv6 nd dad attempts
Set the neighbor query message number sent in
sequence when the interface makes duplicate
address detection. The no command resumes
default value (1).
(2) Configure Send Neighbor solicitation Message Interval
Command Explanation
Interface Configuration Mode
ipv6 nd ns-interval
no ipv6 nd ns-interval
Set the interval of the interface to send neighbor
query message. The NO command resumes
default value (1 second).
(3) Configure static IPv6 neighbor Entries
Command Explanation
Interface Configuration Mode
ipv6 neighbor
interface
Set static neighbor table entries, including neighbor
IPv6 address, MAC address and two-layer port.
no ipv6 neighbor Delete neighbor table entries.