EVS IPDirector Version 6.2 - June 2013 PLAYLIST PANEL User Manual - Manual (Page 61)

How to Load a Playlist from the Database Explorer
To open or load a playlist on a channel from the Database Explorer, proceed as follows:
1. Assign a player channel or the Software Player to the Playlist Panel if you want to load
the playlist.
2. Select the playlist from the Bins or the Playlists view of the Database Explorer.
3. In the Playlists view of the Database Explorer, select the requested playlist in the
Elements grid.
4. Drag it to the top part (Loaded Media and Transport Functions Areas) of the Playlist
Panel.
Note
Dragging it into the Playlist grid would insert the playlist into the previously
loaded one.
If a player has been assigned, the playlist will then be loaded on the IN point of the first
element.
If another playlist had previously been loaded in the Playlist Panel, this latter is replaced
by the new one on the Playlist Panel.
How to Reload a Playlist
How to Cue up a Playlist on the First Element
The Recue function re-loads the playlist on the first frame of the first element.
When a playlist is loaded on a player channel or the Software Player, loading an element
type (clip, train, growing clip) on the same channel will unload the playlist from the
channel. However, it is still possible to load it again on the associated player.
It is possible to recue the playlist in one of the following ways:
• double-click the first element of the playlist in the Playlist Panel
• use the Recue function:
Operation User Interface Button Keyboard Shortcut
Recue
IPDirector - Version 6.2 - User Manual - Playlist Panel
4. Playlist Management 47