EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 72)

4.4.7. Shortening a Clip
You can shorten a clip using the Remote Panel.
To shorten a clip, proceed as follows:
1. Recall the desired clip by pressing the corresponding F_ key.
2. Move the jog dial to browse the clip and reach to the desired Short IN point.
3. Press the IN key to mark a new Short IN point. This new Short IN point is instantly
saved.
4. Move the jog dial to reach the desired Short OUT point.
5. Press the OUT key to mark a new Short OUT point. This new Short OUT point is
instantly saved.
Press the PLAY key to play the clip. The replay will stop at the new Short OUT point (or
after the Short OUT point if the post-roll mode is enabled).
Note
You can use Goto IN and Goto OUT functions to jump immediately onto Short
IN or Short OUT points respectively.
4.4.8. Canceling a Network Copy
In the Remote Panel Interface
To cancel a remote copy, proceed as follows:
1. While the clip is copying, its light flashes green.
2. Pressing CLEAR+the corresponding F_ key to cancel the network copy.
3. A confirmation screen comes up to cancel the network copy. Press the required key.
Cancel network copy ?
[MENU]: Do not cancel copy
[ENTER]: Cancel copy
4. Press ENTER on the Remote Panel to confirm that you cancel the copy. Otherwise,
press MENU.
64 4. Clip Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013