EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 28)

3. Control Modes
3.1. Live, Search or Playback Mode
Multicam can be set in three different basic modes, depending on commands used:
Live (E2E) Mode
This mode selected at start-up can also be selected by pushing the RECORD key.
Multicam records the input signal and plays it at the same time on the program output.
Search Mode
This mode is selected by moving the jog dial.
In this mode, the operator has the opportunity to search for an image, in order to define cue
points or clips. Moving the command knob clockwise will force Multicam to search
forward, moving the command knob counter-clockwise will force it to search backwards.
The most important thing to note is that Multicam never stops recording while searching.
Playback Mode
Pressing the PLAY key selects this last mode.
Multicam plays the incoming signal delayed, a clip or a playlist, in slow motion and of
course continues to record the incoming signal on disks.
3.2. 1PGM+PRV Mode
3.2.1. 1PGM+PRV Mode
Introduction
Multicam has two modes for its basic operation, 1PRV+PGM and Multi PGM:
• The 1PGM+PRV mode is more powerful as it allows interaction between all outputs.
Synchronized replays can be rolled and chained between the cameras with either a
mix, a wipe, or a cut between them.
• The Multi PGM mode is more basic but gives the operator independent control of all
outputs. These outputs can be controlled together (such as jogging back to a certain
action on all outputs) or individually (either PGM 1, 2, or 3).
20 3. Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013