EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 41)

4. Clip Management
4.1. Introduction
4.1.1. Clip Structure
Concepts
A clip is defined by Short IN and Short OUT points. When referring to Short IN and Short
OUT points, the operators usually use the terms IN point and OUT point.
When Short IN and Short OUT points are set, the system automatically write protects a
user definable length of material before and after the Short IN/OUT points respectively,
these are referred to as the guardbands.
For this reason, the IN point before the guardbands and the OUT point after the guardband
are called Protect IN point and Protect OUT point.
Use of Guardbands
It is possible to trim a clip by redefining Short IN and Short OUT points.
If Short IN and Short OUT points are defined, only the fields between those two points will
be played if the sequence is recalled (the same applies when the sequence is included in a
playlist).
Fields between Protect IN and Short IN and fields between Short OUT and Protect OUT
(guardbands) can be reached with the jog. So the Short IN and Short OUT points can be
redefined.
OPERATION MANUAL XSense 11.02
4. Clip Management 33