EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 70)

4.4.6. Restriping Clips
Limitation of the Remote Panel Interface
The function to restripe the timecode of a clip via the Remote Panel is restricted as
follows and you should use the VGA interface to change these parameters:
• You can modify only the primary timecode.
• You cannot modify the date of the clip.
• You cannot modify the type of the primary timecode.
In the Remote Panel Interface
To restripe the timecode of a clip, proceed as follows:
1. Recall the clip by pressing the corresponding F_ key.
2. Move the jog dial to reach the picture where you want to define a new timecode.
3. Press the MENU key to access the secondary menu.
4. Press SHIFT+C to call the Set TC function.
5. Enter the new timecode for the current picture.
6. In 59.94 Hz modes (NTSC), press SHIFT+MENU to select between 'Drop Frame'
and 'Non Drop Frame' modes.
7. Press the D key to select 'CAM' or 'CLIP' mode.
◦ In 'CAM' mode, only the timecode of the camera angle loaded on the primary
channel will be changed.
◦ In 'CLIP' mode, the timecode of all camera angles of the clip will be changed.
8. Press ENTER to confirm or MENU to cancel.
The primary timecode of the entire clip is updated according to the new timecode value so
that the timecode remains continuous over the whole clip.
Next time this function is called, the value previously used will be set as default.
62 4. Clip Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013