EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 115)

Default Transition Duration with Split Audio
• The simplest type of split audio edit that can be performed on an Xsense is to make
the video and audio transitions at the beginning of the clip have different durations,
such as a 12 Frame Video Mix with a 2 sec Audio cross fade.
• The value of the Audio effect duration parameter of the Operational Setup menu (p.3.1
F3) is only taken into account when the Advanced Audio Editing mode is enabled.
Otherwise, the audio effect duration is always locked to the video effect duration,
whatever the value of these parameters.
• If the Audio effect duration parameter in the setup is set to Lock to video, it will never
be possible to adjust independently the duration of the audio and video transitions. If
you want to adjust one of these transitions and the other one follows, please check the
Audio effect duration parameter in the setup, and make sure it is NOT set to Lock to
Video.
How to Activate the Split Audio Mode
To activate the split audio mode, proceed as follows:
1. Enter the Setup menu as described in the Multicam Configuration manual.
2. Enable the Advanced audio editing parameter in the Operational Setup menu (p.3.2
F2).
Split Audio Menu
In Playlist Edit mode, when the Split Audio is activated, the Remote Panel displays V
Base (SHIFT+A) and A Base (SHIFT+B) commands:
V Base A Base Effect Edit all
Insert Speed Fx Dur Delete
Activating the V Base option gives access to the following additional menu. The A Base
menu is similar, but allows corresponding actions on video transitions:
V Base A Base Swap Edit All
A Advance A Delay A Fx Dur A Split
The following table describes the split audio commands in V Base edit. The A Base
commands are the same but relate to the video transitions.
Command Description
A Advance Advances the beginning of the audio transition.
A Delay Delays the beginning of the audio transition.
A Fx Dur Extends the duration of the audio transition on both sides. This creates
an audio delay or advance depending on the modification applied to the
effect duration.
A Split Performs an audio advance or delay by specifying the TC for the
beginning of the transition.
OPERATION MANUAL XSense 11.02
5. Playlist Management 107