EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 30)

Note
In 5CAM configuration (5 recorder channels and 1 player channel) or when
loading a clip where CAM E or F exists, the operational menu will display:
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C --->
By pressing the D key (--->), the operator has access to the D, E and F
cameras. The operation menu becomes:
Rst Cam Local Sync Prv 2nd CTRL
Cam D Cam E Cam F <---
Press the D key (<---) to return to CAM A, B, and C selection.
Rst Cam
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
This function restores the position of cameras on the active channels: CAM A on PGM1,
CAM B on PRV.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the Rst Cam function.
Local
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
This function allows the user to reconnect to the local Xsense after having accessed
distant clips or record trains. The function is highlighted when the user is connected to
both clips and record trains on the local EVS server. It is displayed only on Master/Server
EVS servers when they are connected to the SDTI network.
Sync Prv
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
This option allows the user to synchronize the PRV with the timecode and speed of the
PGM output. This function is not available with remote record trains.
22 3. Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013