EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 33)

Post-Roll
Aud.Met. PgmSpd PostRoll
Mix. Sw to IN Search Pref
When the post-roll mode is enabled, that function is highlighted on the LCD and a “P”
appears on the OSD of the output monitors.
When the user exits Multicam with the post-roll mode on, this mode will still be enabled
when Multicam is restarted.
The post-roll mode works as follows depending on the element played:
• When a clip is played, it will not stop on the Short OUT point, but will continue to play
through the Short OUT point by the post-roll duration defined in the Setup Menu.
• When a record train is played, the same will happen if the Record trains OUTs
parameter is set to “Freeze” in the Operational Setup menu (p.2.3 F1).
• When a playlist is played, the post-roll will apply only to the last clip of the playlist.
Search
Aud.Met. PgmSpd PostRoll
Mix. Sw to IN Search Pref
This function allows the operator to search the database using keywords and ranking.
"Keyword Management" on page 145.
To return to the operational menu, press the MENU key from the Remote Panel.
3.3. Multi PGM Mode
3.3.1. Multi PGM Overview
Introduction
Multicam has two modes for its basic operation, 1PRV+PGM and Multi PGM:
• The 1PGM+PRV mode is more powerful as it allows interaction between all outputs.
Synchronized replays can be rolled and chained between the cameras with either a
mix, a wipe, or a cut between them.
• The Multi PGM mode is more basic but gives the operator independent control of all
outputs. These outputs can be controlled together (such as jogging back to a certain
action on all outputs) or individually (either PGM 1, 2, or 3).
OPERATION MANUAL XSense 11.02
3. Control Modes 25