EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 174)

8.4. Naming a Remote Clip
Note
This operation requires action on both the Remote Panel and the VGA interface.
To name a remote clip, proceed as follows:
1. Select the Clip mode in the Network menu.
2. Select the remote EVS server in the list. The LCD display returns to the normal mode.
3. Go to the Clip screen on the VGA, all banks of remote system are now displayed.
4. Select the clip to name.
5. Type the desired name on the keyboard.
6. Press F1 to name the remote clip.
◦ In CAM mode, only the camera where the cursor is located is named
◦ In CLIP mode, all cameras of the clip where the cursor is located are named.
Note
To be able to rename a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu.
8.5. Modifying IN and OUT Points of a
Remote Clip
In the Remote Panel Interface
To modify the IN and OUT points of a remote clip, proceed as follows:
1. Recall the desired clip.
2. Browse inside the clip until you reach the desired frame.
3. Press the IN or OUT key to mark a new Short IN / Short OUT points.
Note
To be able to rename a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu.
166 8. Operation on XNet Network
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013