EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 71)

In the VGA Interface
To restripe the timecode of a clip, proceed as follows:
1. Move the cursor on the desired clip and press ENTER or click on it with the stylus to
recall it.
2. Press ALT-T on the keyboard to call the SET TC function. The following Set
Timecode screen is displayed:
3. To modify one of the following timecodes:
◦ The LTC timecode and date: Type in the new timecode for the Short IN point and
date of the clip in the Set TC field following the LTC field.
◦ The user-defined timecode and date: Type in the new timecode for the Short IN
point and date of the clip in the Set TC field following the USER field.
◦ The primary TC for this clip: Press the A or B key corresponding to the requested
primary TC.
4. In 59.94Hz modes (NTSC), press the SPACEBAR to select between 'Drop Frame'
and 'Non Drop Frame' modes.
5. Press F2 to select 'CAM' or 'CLIP' mode.
◦ In 'CAM' mode, only the timecode of the camera angle loaded on the primary
channel will be changed.
◦ In 'CLIP' mode, the timecode of all camera angles of the clip will be changed.
6. Press ENTER to confirm or ESC to cancel.
The timecode of the entire clip is updated according to the new timecode value so that the
timecode remains continuous over the whole clip.
OPERATION MANUAL XSense 11.02
4. Clip Management 63