EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 176)

8.8. Creating Local Clips with Remote
Record Trains
In the Remote Panel Interface
To create local clips with remote record trains, proceed as follows:
1. Select the Record mode in the Network menu.
2. Select the remote EVS server in the list. The LCD display returns to the normal mode
3. Press the RECORD key to select the Live mode. A two to three-second delay to Live
has been defined to ensure safe operations.
4. Use the JOG key to go in search mode.
5. Change camera angles if necessary. Changing camera angles on network train will
always switch in pause on the new camera. Refer to the note below about the remote
camera name.
6. Press the IN key to mark your Short IN point of the clip.
7. Search the Short OUT point and press the OUT key to mark it.
8. Select the clip location to store and press the corresponding F_ key.
Note
The label of the remote camera is different in order to identify it easily.
Note
The key flashes during transfer. When the key lights green, the transfer is
completed and the clip is available for playback from the local system.
168 8. Operation on XNet Network
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013