How to leave the slide mode, With the mouse, With the keyboard – EVS IPDirector Version 5.9 - January 2011 Part 8 User’s Manual User Manual
Page 159: 3 how to slide an element using the mouse, How to slide an element using the mouse, Ow to, Lide an, Lement, Sing the, Ouse
IPDirector Version 5.9 – User Manual – Part 8: Editing - IPEdit
EVS Broadcast Equipment – January 2011
Issue 5.9.B
145
H
OW TO
L
EAVE THE
S
LIDE
M
ODE
With the Mouse
To leave the slide mode with the mouse, click anywhere in the Lasso Selection
area above or below the timeline display.
With the Keyboard
To leave the slide mode with the keyboard, press
.
4.11.3 H
OW TO
S
LIDE AN
E
LEMENT
U
SING THE
M
OUSE
To slide one or more elements of the same source media using the mouse,
proceed as follows:
1.
Activate the slide mode on the requested elements by lassoing the whole
elements from right to left, keeping the CTRL key pressed.
See also section 4.11.2 ‘Activating and Deactivating the Slide Mode’, on
page 144.
Î
2.
Click the requested Timeline Track Selection buttons to select or unselect
the tracks you want or do not want to slide.
3.
Click the mouse on one of the elements in slide mode and drag it to the left
or right to slide the elements respectively to the left or to the right.
The new position of the slid element in the timeline, which corresponds to
the slide action applied, is displayed in the Timecode bar.
When you release the mouse, the slide action is applied within 1 sec.
4.
Click anywhere in the Lasso Selection area to leave the slide mode.