EVS IPDirector Version 5.9 - January 2011 Part 8 User’s Manual - Manual (Page 146)

Issue 5.9.B IPDirector Version 5.9 – User Manual – Part 8: Editing - IPEdit
EVS Broadcast Equipment - January 2011
132
H
OW TO
T
RIM AN
E
LEMENT
U
SING THE
S
HUTTLE
PRO
To trim an element using the ShuttlePRO, proceed as follows
1.
Select the Insert of Overwrite mode to be applied in the trim
action by clicking Insert/Overwrite Global mode button.
2. If the trim mode is not active, do the following:
a) Position the nowline next to the transition on which to activate the trim
mode.
b) Select the Track Selection buttons of the tracks to be taken into account
in the trim action.
c) Press the Trim key on the ShuttlePRO.
3. If required, change the trim mode by clicking on:
• the left of the transition to activate the Trim Left mode
• the right of the transition to activate the Trim Right mode
• the transition itself to activate the Trim Left and Right mode (roll mode)
again.
4. Move the jog right or left to shift the IN or OUT point of the trimmed element
respectively to the right or to the left.
The selected tracks of the element are trimmed according to the active trim mode
up to the requested position.
Note
If the limits of the A/V material are reached, you cannot drag the
transition further.