Inserting a freeze effect in a playlist element, Introduction, How to insert a freeze in a playlist element – EVS IPDirector Version 5.8 - July 2010 Part 6 User's Manual User Manual
Page 94: Nserting a, Reeze, Ffect in a, Laylist, Lement
IPDirector Version 5.8 – User Manual – Part 6: Playout – Playlist Panel
EVS Broadcast Equipment – July 2010
Issue 5.8.B
83
default values, refer to section 1.9.3 ‘Default Transition Settings’ on page 123.
Resetting parameters to default can be done in two ways:
•
Selecting Reset transition to default option from the Playlist Element
contextual menu
•
using a macro command, previously configured to correspond to the option.
Refer to section 1.7.9 ‘Applying a Macro Command to Trigger Playout Effects’
on page 94 for information on using macro commands and to section 1.9.5
‘Playlist Macro Commands Settings’ on page 127 for information on configuring
macro commands.
1.7.6 I
NSERTING A
F
REEZE
E
FFECT IN A
P
LAYLIST
E
LEMENT
I
NTRODUCTION
You can insert a Freeze effect in a playlist element, at a certain time code. The
frame on which the Freeze is inserted will become a still image for the specified
duration.
H
OW TO
I
NSERT A
F
REEZE IN A
P
LAYLIST
E
LEMENT
To insert a freeze in a Playlist element, proceed as follows:
1.
Browse the playlist element to the image that you want to freeze.
2.
Right-click the playlist element and select Insert Freeze:
The Freeze window opens.
3.
The Freeze at TC field shows the TC IN of the selected playlist element. If
needed, enter the TC value where you want the Freeze effect to start.
The maximum duration, shown below the Duration field, is calculated from
the Freeze at TC value to TC OUT.