Http, Enabling http, Configuring http settings – Xerox WorkCentre 6400 User Manual
Page 43: Enabling http configuring http settings
Network Configuration
WorkCentre 6400 Multifunction Printer
System Administrator Guide
43
HTTP
Hypertext Transfer Protocol (HTTP) is a request-response standard protocol between clients and
servers. Clients making HTTP requests are referred to as UAs while servers responding to these requests
for resources such as HTML pages, are referred to as origin servers. There can be any number of
intermediaries, such as tunnels, proxies, or gateways between User Agents and Origin Servers.
Enabling HTTP
By default HTTP is enabled. If you disable HTTP, you will need to enable it at the printer before you can
access CentreWare IS.
Note:
If your printer is locked, you must log in as a system administrator. For details, see
1.
At the printer control panel, press the Machine Status button, then touch the Tools tab.
2.
Touch Network Settings > Advanced Settings.
3.
Touch Continue.
4.
Touch HTTP Settings.
5.
Touch Enable, then touch Save.
Configuring HTTP Settings
Note:
If your printer is locked, you must log in as a system administrator. For details, see
1.
In CentreWare IS, click Properties > Connectivity > Protocols > HTTP.
2.
In Keep Alive Timeout, type the time between 1 and 60 seconds to specify how long the printer
will wait for a response from a connected user before terminating the connection. The default
value is 15 seconds.
Note:
Increasing the Keep Alive Timeout time can cause connections to slow down.
3.
Change the HTTP Port Number if required. The default is 80.
4.
Click Apply.