Xerox WorkCentre 6400 - Manual (Page 153)

Administrator Tools
WorkCentre 6400 Multifunction Printer
System Administrator Guide
153
Touch Screen Settings
Setting the Default Touch Screen View
Note: If your printer is locked, you must log in as a system administrator. For details, see System
Administrator Access at the Control Panel on page 15.
1. At the printer control panel, press the Machine Status, then touch the Tools tab.
2. Touch Device Settings > General > Entry Screen Defaults.
3. Touch Default Pathway to set the default touch screen display.
4. Touch Service Default to set the screen that displays when the Services button is pressed.
5. Touch Job Status Default to specify what jobs display when the Job Status button is pressed.
6. Touch Save.
System Time Out
You can specify the time that the printer waits until returning to the default touch screen view.
Note: If your printer is locked, you must log in as a system administrator. For details, see System
Administrator Access at the Control Panel on page 15.
1. At the printer control panel, press the Machine Status, then touch the Tools tab.
2. Touch Timers > System Timeout.
3. Touch Enable.
4. Touch the field under Timeout and use the arrows to adjust the time between 15 and 600
seconds.