Yamaha 006IPTO-F0 - Manual (Page 76)

76
Chapter 6—Input Channels
DM1000 Version 2—Owner’s Manual
4 Use the EQUALIZER [Q], [FREQUENCY], and [GAIN] controls to adjust the Q,
frequency, and gain of the band selected in Step 3.
See page 68 for more information on EQ.
Pairing Input Channels
On the DM1000, you can pair adjacent odd-even Input Channels or counterpart channels
on Layer 1 and Layer 2 that share the same physical fader. Faders and most parameters of
paired channels are linked for stereo operation. Paired channels’ linked parameters and
non-linked parameters (that are available for independent control) are listed below:
* You can set this parameter for each channel independent-
ly if the GANG button is turned off on the
/INS/DLY |
DLY page.
** You can set this parameter for each channel independent-
ly on the EQ | ATT page, but the paired channel settings
are linked on the EQ | Edit and View pages.
To pair channels, or to cancel channel pairs, you can use the [SEL] buttons on the top panel
or access the Pair/Group pages.
Tip:
• Pressing and holding down the button selected in Step 3 resets the corresponding band gain.
• Pressing the SELECTED CHANNEL [HIGH] and [LOW] buttons simultaneously resets the
Q, frequency and gain for each band.
Linked parameters
[SEL] buttons
Faders
Channel on/off
Insert on/off
Solo on/off
Solo Safe
Aux on/off
Aux Send level
Aux Sends as Pre or Post
Gate
Comp settings
EQ settings
Fader group
Mute group
Fade time
Recall Safe
Non-linked parameters
Input patches
Insert patches
Output patches
Comp insert position
Phase
Delay on/off
Delay time*
Delay feedback
Delay mix
Routing
Pan, Follow Pan
Surround pan
Aux Send pan
Balance
Attenuators**