Yamaha 006IPTO-F0 - Manual (Page 203)

Automix Main Page
203
DM1000 Version 2—Owner’s Manual
Automix
16
J OVERWRITE section
This section enables you to select parameters to be recorded on the first pass, and rere-
corded (i.e., overwritten) on subsequent passes. You can select or deselect these param-
eters while recording is in progress (see page 190).
K AUTOMIX ENABLED/DISABLED
This parameter enables or disables the Automix. When the parameter is set to DISABLE,
you cannot record or play back an Automix. If the ESAM function is enabled, you can-
not enable the Automix.
L NEW
Move the cursor to the NEW button, then press [ENTER] to create a new Automix.
When you create a new Automix, a Scene recall event to recall the current Scene (i.e., the
last Scene recalled) is automatically inserted at the start of the Automix. (You can edit
this event so that you will be able to recall another Scene.)
M UNDO
Move the cursor to this button, then press [ENTER] to undo various Automix opera-
tions (Undo function). When you record new events in an Automix, or when you per-
form an offline edit, the current Automix data is copied to the Undo buffer. You can
retrieve the data from the buffer by moving the cursor to the UNDO button and press-
ing [ENTER] while Automix is stopped. You can also cancel the Undo operation (Redo
function).
N INSERT
Move the cursor to this button, then press [ENTER] to insert the current mix parame-
ters into the current Automix data. This is useful when you want to quickly replace the
Automix data in the specified range (e.g., to replace dialogs). Refer to “Inserting Mix
Parameters into Automix” on page 193
O AUTO REC
Move the cursor to the AUTO REC button, then press [ENTER] to place the DM1000
in Automix record ready mode. The button becomes highlighted. In this state, when the
DM1000 receives the appropriate timecode, it automatically starts Automix recording.
Record ready mode is not canceled, even if Automix recording is stopped, unless you
move the cursor to this button and press [ENTER].
P REC
Move the cursor to the REC button, then press [ENTER] to place the DM1000 in Auto-
mix record ready mode. The button starts to flash. In this state, when the DM1000
receives the appropriate timecode, it automatically starts Automix recording.
Unlike the AUTO REC button, however, record ready mode is canceled when recording
is stopped.
If you move the cursor to this button and press [ENTER] during Automix playback, the
DM1000 engages record ready mode.
Q PLAY
If the timecode source is set to internal, move the cursor to the PLAY button and press
[ENTER]. Automix recording or playback starts.
If you selected an external timecode source, as soon as the DM1000 receives the external
timecode, recording or playback starts, and this button turns on automatically. After you
stop Automix by pressing the STOP button or ABORT button, you can restart recording
or playback by pressing this button as long as the DM1000 is still receiving timecode.
Tip:
• The Undo buffer is cleared when you turn off the power to the DM1000. If you want to
save the contents of the Undo buffer, perform the undo operation, then store the Automix.
• However, you cannot undo the operations performed on the Event Edit page.