Yamaha 006IPTO-F0 User Manual
Page 139
Surround Monitoring
139
DM1000 Version 2—Owner’s Manual
Surround Functions
11
The following diagram shows an example in 5.1 Surround mode and 3-1 Monitor Matrix
mode.
• BASS MANAGEMENT
You can set the filter and attenuator settings for each Surround Monitor Channel using
eight preset Bass Management modes. The following presets are available:
ATT1: Adjusts the level difference between LR and LsRs.
ATT2: Adjusts the level difference between C and Bs.
AMP: Corrects the LFE channel level.
HPF1–3: Cut the low range so that the speakers’ supporting frequency ranges will not interfere with the
subwoofer signals.
HPF1–2: Cut the high range so that the subwoofer’s supporting frequency ranges will not interfere with
other speakers’ signals.
You can set the Bass Management parameters in the following ranges:
The HPF 1, 2, 3, and LPF 1 & 2 values indicate a cut-off frequency and a filter response. For example,
“80-12” means a cutoff frequency of 80 Hz and a filter response of –12 dB/octave.
“L” means Linkwitz filter. Other filters are Butterworth.
Note: You can patch the Surround Monitor Matrix channels to the output connectors.
Presets
Parameters
No.
Title
HPF 1, 2, 3
LPF1
LPF2
ATT 1 & 2
AMP
1
DVD LFE80Hz
80–12
80–24
80–24
0
10
2
DVD LFE120Hz
80–12
120–42
80–24
0
10
3
Movie LFE80Hz
80–12
80–24
80–24
–3
10
4
Movie LFE120Hz
80–12
120–42
80–24
–3
10
5
Bypass
THRU
THRU
MUTE
0
0
THXD
THX DVD
80-12L
120-42
80-24L
0
10
THXF
THX Movie
80-12L
120-42
80-24L
–3
10
THXM
THX Music
80-12L
120-42
80-24L
0
10
Note:
• If you select preset THXD or THXF, you cannot change the parameters.
• If you select preset THXM, you can switch AMP between 10 dB and 0 dB. However, you
cannot change other parameters.
Parameters
Range
HPF 1, 2, 3
THRU, 80-12, 80-12L, 80-24, 80-24L
LPF1
THRU, 80-24, 80-24L, 120-42
LPF2
THRU, 80-24, 80-24L, MUTE
ATT 1 & 2
0 to –12 dB (1 dB steps)
AMP
0 to +12 dB (1 dB steps)